1325 Datasheet

Download or read online Pomona Electronics 1325 pdf datasheet.

1 of 1
Designed to fit on the end of any 22 AWG to 18 AWG wire.
Cross hole wire entry fits wires up to .12” (3mm) diameter.
Available with tarnish resistant nickel or gold plating for
very low contact resistance.
Model 5230 is rated to temperatures up to +302°F
Set screw simplifies assembly of test leads and jumpers
by using a flat blade screwdriver.
Fits standard panel and binding post banana jacks .161” to
.166” (4,0mm to 4,2mm) diameter.
Banana Jack:
Beryllium Copper, Gold Plated
Banana Plug:
Body – Brass, Nickel Plated (Model 5406 Gold Plated)
Spring – Beryllium Copper, Nickel Plated (Model 5406 Gold Plated)
ABS (Model 5230 Polyphenylene Sulfide)
Set Screw:
Steel, Zinc Plated, 8-32 Single Slot
For CE compliance and for personal safety, do not hold in hand when voltages exceed 33 Vrms/70 Vdc.
Maximum voltage for hands free use in controlled testing environments: 5000 Vrms Max. Do not use on
circuits where transient stresses can exceed the rated voltage.
15 Amps
Maximum Operating Temperature:
Ordering Information
Model: 1325-color
Nickel Plated Banana with ABS Insulation
Color: 0=Black, 1=Brown, 2=Red, 3=Orange, 4=Yellow, 5=Green, 6=Blue, 7=Violet, 8=Gray, 9=White,
02=set of Black and Red
Ordering example:
1325-5 (1325 with green ABS insulation)
Model: 5406-0 Gold Plated Banana Plug with ABS Black Insulation
Model: 5406-2 Gold Plated Banana Plug with ABS Red Insulation
Model: 5230-0 Nickel Plated Banana with High Temperature Black Insulation (Polyphenylene Sulfide)
Model: 5230-6 Nickel Plated Banana with High Temperature Blue Insulation (Polyphenylene Sulfide)
Model: 6546 Package of ten 1325, one of each color.
Model: 4914 Replacement Set Screws, package of 100.
Sales: 800-490-2361
Technical Support:
Fax: 425-446-5844
Europe: 31-(0) 40 2675 150 International: 425-446-5500
Where to Buy:
Model 1325, 5230, 5406, 6546
Standard Banana Jacks, Solderless and Stackable
+122ºF (+50ºC) max. (Model 5230: +302ºF (+150ºC) max.)
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm),
.xxx = ± .005” (,127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks are
the property of their respective companies.
Copyright © 2009
Standard Banana Vertical
Stack-Up Jack
D1093603 Rev. 101
Page 1 of 1

Comments to this Datasheet