Datasheets»TI (Texas Instruments)»CD74HC4067SME4 Datasheet

CD74HC4067SME4 Datasheet

Download or read online TI (Texas Instruments) CD74HC4067SME4 16-CHANNEL, SGL ENDED MULTIPLEXER, PDSO24 pdf datasheet.



Page
1 of 16
next
Data sheet acquired from Harris Semiconductor
SCHS209C
February 1998 - Revised July 2003
Features
• Wide Analog Input Voltage Range
• Low “ON” Resistance
- V
= 4.5V. . . . . . . . . . . . . . . . . . . . . . . . . . . 70 (Typ)
CC
- V
= 6V . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 (Typ)
CC
• Fast Switching and Propagation Speeds
• “Break-Before-Make” Switching. . . . . 6ns (Typ) at 4.5V
• Available in Both Narrow and Wide-Body Plastic
Packages
• Fanout (Over Temperature Range)
- Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads
- Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads
• Wide Operating Temperature Range . . . -55
• Balanced Propagation Delay and Transition Times
• Significant Power Reduction Compared to LSTTL
Logic ICs
• HC Types
- 2V to 6V Operation
- High Noise Immunity: N
= 30%, N
IL
at V
= 5V
CC
• HCT Types
- 4.5V to 5.5V Operation
- Direct LSTTL Input Logic Compatibility,
V
= 0.8V (Max), V
= 2V (Min)
IL
IH
- CMOS Input Compatibility, I
l
Pinout
CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper IC Handling Procedures.
©
Copyright
2003, Texas Instruments Incorporated
16-Channel Analog Multiplexer/Demultiplexer
Description
The CD74HC4067 and CD74HCT4067 devices are digitally
controlled analog switches that utilize silicon-gate CMOS
technology to achieve operating speeds similar to LSTTL,
with the low power consumption of standard CMOS
integrated circuits.
These analog multiplexers/demultiplexers control analog
voltages that may vary across the voltage supply range.
They are bidirectional switches thus allowing any analog
input to be used as an output and vice-versa. The switches
have low “on” resistance and low “off” leakages. In addition,
these devices have an enable control which when high will
disable all switches to their “off” state.
Ordering Information
o
o
C to 125
C
PART NUMBER
CD74HC4067E
CD74HC4067M
CD74HC4067M96
CD74HC4067SM96
= 30% of V
IH
CC
CD74HCT4067M
NOTE: When ordering, use the entire part number. The suffix 96
denotes tape and reel.
1 A at V
, V
OL
OH
CD74HC4067 (PDIP, SOIC, SSOP)
CD74HCT4067 (SOIC)
TOP VIEW
COMMON
1
24
V
INPUT/OUTPUT
CC
I
2
23
I
7
8
I
3
22
I
6
9
I
4
21
I
5
10
I
5
20
I
4
11
I
6
19
I
3
12
I
7
18
I
2
13
I
8
17
I
14
1
I
9
16
I
0
15
S
10
15
E
0
14
S
S
11
1
2
GND
12
13
S
3
1
CD74HC4067,
CD74HCT4067
High-Speed CMOS Logic
TEMP. RANGE
o
(
C)
PACKAGE
-55 to 125
24 Ld PDIP
-55 to 125
24 Ld SOIC
-55 to 125
24 Ld SOIC
-55 to 125
24 Ld SSOP
-55 to 125
24 Ld SOIC
Specifications of TI (Texas Instruments) CD74HC4067SME4
Mfr Package Description:
GREEN, PLASTIC, SSOP-24
Lead Free:
Yes
EU RoHS Compliant:
Yes
China RoHS Compliant:
Yes
Technology:
CMOS
Package Shape:
RECTANGULAR
Package Style:
SMALL OUTLINE, SHRINK PITCH
Surface Mount:
Yes
Terminal Form:
GULL WING
Terminal Pitch:
0.6500 mm
Terminal Finish:
NICKEL PALLADIUM GOLD
Terminal Position:
DUAL
Number of Functions:
1
Number of Terminals:
24
Package Body Material:
PLASTIC/EPOXY
Temperature Grade:
MILITARY
Number of Inputs:
16
Switch-on Time-Max:
60 ns
Switch-off Time-Max:
58 ns
Analog IC - Other Type:
SGL ENDED MULTIPLEXER
Off-state Isolation-Nom:
75 dB
Analog Input Voltage Limit-Max:
4.5 V
Operating Temperature-Max:
125 Cel
Operating Temperature-Min:
-55 Cel
Supply Voltage-Max (Vsup):
6 V
Supply Voltage-Min (Vsup):
2 V
Supply Voltage-Nom (Vsup):
4.5 V
On-state Resistance Match-Nom:
10 ohm
On-state Resistance-Max (Ron):
180 ohm

Summary of Contents

Page 1

Data sheet acquired from Harris Semiconductor SCHS209C February 1998 - Revised July 2003 Features Wide Analog Input Voltage Range Low ON Resistance - V 4.5V ...

Page 2

Functional Diagram BINARY DECODER STAGES STAGES ...

Page 3

Absolute Maximum Ratings DC Supply Voltage (Voltages Referenced to Ground -0. Input Diode Current For V < ...

Page 4

DC Electrical Specifications (Continued) CONDITIONS PARAMETER SYMBOL V (V) I Quiescent Device Current GND I 0mA O HCT TYPES High Level Input Voltage Low Level Input Voltage Maximum ON ...

Page 5

Switching Specifications Input PARAMETER SYMBOL Switch Turn PZH PZL E to Out Switch Turn PZH PZL Sn to Out Switch Turn Off PHZ PLZ E ...

Page 6

Analog Channel Specifications PARAMETER Switch Frequency Response Bandwidth at -3dB (Figure 2) Sine Wave Distortion Feedthrough Noise E to Switch Feedthrough Noise S to Switch Switch OFF Signal Feedthrough (Figure 3) Switch Input Capacitance Common Capacitance, C COM ...

Page 7

Analog Test Circuits V CC 0.1 F SWITCH FIGURE 4. FREQUENCY RESPONSE TEST CIRCUIT V CC SWITCH 600 ALTERNATING ON AND OFF 6ns 600 1MHz CONT ...

Page 8

PACKAGING INFORMATION (1) Orderable Device Status CD74HC4067DB PREVIEW CD74HC4067E ACTIVE CD74HC4067EE4 ACTIVE CD74HC4067M ACTIVE CD74HC4067M96 ACTIVE CD74HC4067M96E4 ACTIVE CD74HC4067M96G4 ACTIVE CD74HC4067ME4 ACTIVE CD74HC4067MG4 ACTIVE CD74HC4067SM PREVIEW CD74HC4067SM96 ACTIVE CD74HC4067SM96E4 ACTIVE CD74HC4067SM96G4 ACTIVE CD74HCT4067M ACTIVE CD74HCT4067ME4 ACTIVE CD74HCT4067MG4 ACTIVE (1) ...

Page 9

Important Information and Disclaimer:The information provided on this page represents TI's knowledge and belief as of the date that it is provided. TI bases its knowledge and belief on information provided by third parties, and makes no representation ...

Page 10

TAPE AND REEL INFORMATION All dimensions are nominal Device Package Package Type Drawing CD74HC4067M96 SOIC DW CD74HC4067SM96 SSOP DB PACKAGE MATERIALS INFORMATION Pins SPQ Reel Reel A0 (mm) Diameter Width (mm) W1 (mm) 24 2000 330.0 24.4 10.75 24 ...

Page 11

Device Package Type CD74HC4067M96 SOIC CD74HC4067SM96 SSOP PACKAGE MATERIALS INFORMATION Package Drawing Pins SPQ Length (mm 2000 DB 24 2000 Pack Materials-Page 2 11-Mar-2008 Width (mm) Height (mm) 346.0 346.0 41.0 346.0 346.0 ...

Page 12

DB (R-PDSO-G) 28 PINS SHOWN 0, 2,00 MAX PINS DIM A MAX A MIN NOTES: A. All linear dimensions are in millimeters. B. This drawing is subject to change without notice. C. Body dimensions do not ...

Page 13

N (RPDIPT24) 1.222 (31,04) MAX 24 1 0.070 (1,78) MAX 0.100 (2,54) 0.021 (0,53) 0.010 (0,25) 0.015 (0,38) NOTES: A. All linear dimensions are in inches (millimeters). B. This drawing is subject to change without notice. C. Falls within JEDEC ...

Page 15

N (R-PDIP-T) 24 PIN SHOWN 0.060 (1,52) TYP 0.021 (0,53) 0.010 (0,25) 0.015 (0,38) PINS DIM A MAX A MIN NOTES: A. All linear dimensions are in inches (millimeters). B. This drawing is subject to change ...

Page 16

Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or service without notice. Customers should obtain the ...

Comments to this Datasheet