Datasheets»Fidelix»FMS1616LAX-XXEX Datasheet

FMS1616LAX-XXEX Datasheet - Page 9

Download or read online Fidelix FMS1616LAX-XXEX 16m 1mx16 Low Power Sdram pdf datasheet.



Page
9 of 46
prevnext
Burst Length
Starting Column Address
2
4
8
Full Page(y)
Table 2. Burst Length Definition.
Operating Mode
The normal operating mode is selected by setting M7 and M8
to zero; the other combinations of values for M7 and M8 are
reserved for future use and/or test modes. The programmed
burst length applies to both READ and WRITE bursts.Test
modes and reserved states should not be used because
unknown operation or incompatibility with future versions may
result.
CAS Latency
The CAS latency is the delay, in clock cycles, between the
registration of a READ command and the availability of the first
piece of output data. The latency can be set to one, two,
or three clocks. If a READ command is registered at clock
edge r, and the latency is q clocks, the data will be available
by clock edge r + q. The DQs will start driving as a result of
the clock edge one cycle earlier (r + q- 1), and provided that
the relevant access times are met, the data will be valid by
clock edge r + q. For example, assuming that the clock cycle
time is such that all relevant access times are met, if a READ
command is registered at T0 and the latency is programmed
to two clocks, the DQs will start driving after T1 and the data
will be valid by T2, as shown in Figure 2.
Rev0.3, May., 2010
Type=Sequential
A0
0
1
A1 A0
0 0
0 1
1 0
1 1
A2 A1 A0
0 0 0
0-1-2-3-4-5-6-7
0 0 1
1-2-3-4-5-6-7-0
0 1 0
2-3-4-5-6-7-0-1
0 1 1
3-4-5-6-7-0-1-2
1 0 0
4-5-6-7-0-1-2-3
1 0 1
5-6-7-0-1-2-3-4
1 1 0
6-7-0-1-2-3-4-5
1 1 1
7-0-1-2-3-4-5-6
n=A0-A7(location 0-y)
Bn, Bn+1, Bn+2…..Bn,…
Reserved states should not be used as unknown operation or
incompatibility with future versions may result.
Write Burst Mode
When M9=0, the burst length programmed via M0-M2 applies to
both READ and WRITE bursts; when M9=1, the programmed
burst length applies to READ bursts, but write accesses are
single-location (non-burst) accesses.
FMS1616LAx-xxEx
Order of Accesses within a Burst
Type=Interleaved
0-1
0-1
1-0
1-0
0-1-2-3
0-1-2-3
1-2-3-0
1-0-3-2
2-3-0-1
2-3-0-1
3-0-1-2
3-2-1-0
0-1-2-3-4-5-6-7
1-0-3-2-5-4-7-6
2-3-0-1-6-7-4-5
3-2-1-0-7-6-5-4
4-5-6-7-0-1-2-3
5-4-7-6-1-0-3-2
6-7-4-5-2-3-0-1
7-6-5-4-3-2-1-0
Not supported

Comments to this Datasheet